This is the most popular pattern used in touchscreen sensors.
Both horizontal and vertical electrodes are made of diamond-shaped electrodes that are connected through narrow bridges. Bridges are overlapping to form the nodes of the touchscreen sensor: 

The parameters of Diamond Double Layer pattern:

  -  Wx and Wy are the cell dimensions (in mm)
  -  g is the gap between the diamonds (in mm)
  -  bx and by are values of the bridge width of vertical and horizontal electrodes, respectively (in mm).

You can add infills (electrically floating parts that are also called "dummies") in your design by simply checking this checkbox:

Dimensions of infills are defined by the cell dimensions and the above parameters of the electrodes: 

Did this answer your question?